Details
The MD04 is a medium power motor driver and is an upgraded replacement for the MD03, the main features are ease of use and flexibility. The motor's power is controlled by on-board Pulse Width Modulation (PWM) generators driving the H-Bridge Transistors.
Voltage - 5v - 24v
Current - up to 20A
Control 1 - 0v - 2.5v - 5v Analogue for Reverse - Stop - Forward
Control 2 - 0v - 5v (or PWM equiv.) with separate direction control
Control 3 - RC Mode - Controlled by standard Radio Control system. Direct connection to RC receiver. (1mS - 2mS pulse with 1.5mS center off).
Control 4 - I2C Interface, full control, acceleration and status reporting. Up to 8 modules on bus. SCL speed up to 1MHz
Control 5 - Serial at 5v levels and up to 115.2k baud rate
Current limiter - Preset at 20A
Temperature limiter - Reduces power gracefully if module overheats
Size - 113mm x 52mm x 30mm
Full MD04 Documentation
Examples
I2C bus tutor - general I2C guide
Arduino - control using an I2C interface and display using the LCD05
ATMEGA32 - Simple communication example
PIC18F4410 - driving the motor and displaying variables on the LCD03
PIC24FJ16GA002 - reading the result and displaying on a LCD03/LCD05
Picaxe18x - I2C communication example
Specifications
Part. No. : | MD04 |
Related Products
-
MD22 Dual 5A H-Bridge
The MD22 is a robust low/medium power motor driver, designed to supply power for two motors. -
330012 SyRen25 25A Motor Controller
The SyRen 20 can supply a single DC brushed motor with up to 20A continuously. Peak currents of 30A are achievable for a few false -
807489 MD14 - 24Volt 5Amp H Bridge Motor Drive
The MD14 is a medium power motor driver, designed to provide the easiest motor control possible to a single motor. Adjustmentfalse -
581451 1451 - VNH5019 Motor Driver Carrier
This carrier board for ST’s VNH5019 motor driver IC operates from 5.5 to 24 V and can deliver a continuous 12 A (30 A peak). false