This is a blank MiFare Classic tag embedded in a 'porcelain' looking phone charm. These tags are like those often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away. Since this tag has a small antenna, it has to be closer to the antenna than, say, a large credit-card sized tag.
These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!
These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.
- 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
- Built in encryption engine with 48-bit key
- 4 Byte unique identifier burned into the chip
- 13.56 MHz frequency
- 15mm x 36mm x 3.1mm /0.59" x 1.4" x 0.12"
- loop is 140mm/5.5"
- 2.6 grams with loop, 1.65 grams without
- Works about 1" away from RFID reader
|Part. No. :||884|
Questions on MiFare Classic (13.56MHz RFID/NFC) Charm - 1KB
No questions asked yetRegister or Login to ask a question.
Excl. Tax:€36.99Incl. Tax:€45.13