808427 Arduino 4 Relays Shield

Arduino 4 Relays Shield

The Arduino 4 Relays Shield is a solution for driving high power loads that cannot be controlled by Arduino's digital IOs, due to the current and voltage limits of the controller.
Prezzi IVA inclusa
€ 23,79 Prezzo
€ 19,50 + VAT

 

Dettagli

The Arduino 4 Relays Shield is a solution for driving high power loads that cannot be controlled by Arduino's digital IOs, due to the current and voltage limits of the controller.

The Shield features four relays, each relay provides 2 pole changeover contacts (NO and NC); in order to increase the current limit of each output the 2 changeover contacts have been put in parallel. Four LEDs indicate the on/off state of each relay.

Operating Voltage

5V

Coil current consumption

140 mA (with all releays on, about 35 mA each)

Single pole chargeover contact maximum current

@ 30 V DC 2A

Maximum load voltage

48 V

Maximum switching capacity

60 W

Go to the Arduino 4 Relays Shield LABS Page You can find resources, tutorials, sample projects related to everyday life with your Arduino 4 Relays Shield 

EAGLE files: arduino-4-Relays-Shield-reference-design.zip
Schematic: arduino-4-Relays-Shield-reference-design.pdf

The relays are controlled by the following Arduino board pins:

 

Relay 1 = Arduino pin 4

Relay 2 = Arduino pin 7

Relay 3 = Arduino pin 8

Relay 4 = Arduino pin 12

 

 

The shield features several TinkerKit input/output and communication interfaces. Connecting TinkerKit modules can simplify the creation of a project or a prototype. 

 

The on-board connectors are :

  • 2 TinkerKit Inputs: IN2 and IN3 (in white), these connectors are routed to the Arduino A2 and A3 analog input pins.
  • 2 TinkerKit Outputs: OUT5 and OUT6 (in orange), these connectors are routed to the Arduino PWM outputs on pins 5 and 6.
  • 2 TinkerKit TWI: these connectors (4-pin in white) are routed on the Arduino TWI interface. Both connect to the same TWI interface to allow you to create a chain of TWI devices.

The maximum length and width of the 4 Relays Shield PCB are 2.7 and 2.1 inches respectively. Four screw holes allow the Shield to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins. 

Specifiche

Part. No. : A000110
Interfaccia : I/O
Tensione : 5
Tipo Shield : Rele', Potenza

Tags prodotto

Usa gli spazi per tag separati. Usa virgolette singole (') per frasi.

Questions on Arduino 4 Relays Shield

No questions asked yet

Fai una domanda (Registrati oppure Esegui il Login ).
Fai una domanda (Registrati oppure Esegui il Login ).
  1. Relay Shield v3.0

    808368 Relay Shield v3.0

    Shield per Arduino con 4 relè elettromeccanici per interfacciare i vostri dispositivi a carichi funzionanti a tensioni elevate.
    Tasse escluse:
    € 12,00
    IVA inclusa:
    € 14,64
      Confronta

Se hai trovato questo prodotto ad un prezzo migliore, inviaci una segnalazione, faremo tutto il possibile per accontentarti.

Price Match



* Campi richiesti

Il nostro Reparto Vendite rispondera' entro 24 ore via e-mail.

Grazie per la tua fiducia in Robot Italy!