Dettagli
The MyoWare LED Shield is designed to pair with the MyoWare Muscle Sensor. The blue 10-segment bar graph shows the magnitude of the measured signal. The more muscle activation measured, the higher up the board the lit LEDs will go. With this shield you will be provided with a visual representation of the signals provided by the MyoWare Muscle Sensor and an on-board lithium polymer (LiPo) power source.
This shield is likely to be the top board in a stack, so solder on some 1x3 male headers and plug into the sensor board. The power is supplied on the LED shield, but controlled by the power switch on the sensor. Once the stack is assembled, snap on some electrodes and stick the sensor on the target muscle.
The MyoWare Muscle Sensor to which this shield attaches is an Arduino-powered, all-in-one electromyography (EMG) sensor from Advancer Technologies. The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle, outputting 0-Vs Volts depending on the amount of activity in the selected muscle, where Vs signifies the voltage of the power source.
Note: The MyoWare Power Shield and the MyoWare LED Shield both provide power, but at slightly different voltages. Don’t use both of these shields at the same time.
Documents:
Specifiche
Part. No. : | DEV-13688 |
Questions on MyoWare LED Shield
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
712969 Biomedical Sensor Pad (10 pack)
This is a 10 pack of Biomedical Sensor Pads, disposable electrodes that can be used to measure EEG, ECG and EMG levels. thesefalse -
713723 MyoWare Muscle Sensor
The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle; outputting 0-Vs Volts dependifalse -
713684 MyoWare Power Shield
The MyoWare Power Shield is designed to take two standard CR2032 coin cell batteries to power the MyoWare Muscle Sensor. -
713709 MyoWare Proto Shield
With this shield you will be able to use the area provided to solder on whatever custom circuitry you can come up with. This false -
714109 MyoWare Cable Shield
Shield per il sensore muscolare Myoware, estende i sensori tramite un jack da 3.5mm. Consente di utilizzare il Myoware a distanza