Dettagli
This is the MyoWare Proto Shield, a simple proto-board for your MyoWare Muscle Sensor. With this shield you will be able to use the area provided to solder on whatever custom circuitry you can come up with. This shield provides 8 x 15 solderable through holes on a standard 0.1" grid.
The MyoWare Proto Shield is equipped with two rows of 3-pin plated through holes on each end of the board. This allows for standard 0.1" headers to be used to stack the shield with other MyoWare boards.
The MyoWare Muscle Sensor, that this shield attaches to, is an Arduino-powered, all-in-one electromyography (EMG) sensor from Advancer Technologies. The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle; outputting 0-Vs Volts depending the amount of activity in the selected muscle, where Vs signifies the voltage of the power source.
Documents:
Specifiche
Part. No. : | BOB-13709 |
Questions on MyoWare Proto Shield
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
712969 Biomedical Sensor Pad (10 pack)
This is a 10 pack of Biomedical Sensor Pads, disposable electrodes that can be used to measure EEG, ECG and EMG levels. thesefalse -
713723 MyoWare Muscle Sensor
The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle; outputting 0-Vs Volts dependifalse -
713684 MyoWare Power Shield
The MyoWare Power Shield is designed to take two standard CR2032 coin cell batteries to power the MyoWare Muscle Sensor. -
713688 MyoWare LED Shield
The MyoWare LED Shield is designed to pair with the MyoWare Muscle Sensor. The blue 10-segment bar graph shows the magnitude false -
713959 Ultrasonic Sensor - HC-SR04
This is the HC-SR04 ultrasonic ranging sensor. This economical sensor provides 2cm to 400cm of non-contact measurement functifalse -
714109 MyoWare Cable Shield
Shield per il sensore muscolare Myoware, estende i sensori tramite un jack da 3.5mm. Consente di utilizzare il Myoware a distanza