Dettagli
This small breakout board couples an Electret microphone (100Hz–10kHz) with a 60x mic preamplifier to amplify the sounds of voice, claps, door knocks or any sounds loud enough to be picked up by a microcontroller’s analog-to-digital converter. Each breakout comes fully assembled and works from 2.7V up to 5.5V.
The Electret Mic Breakout translates amplitude (not volume) by capturing sound waves between two conducting plates (one a vibrating diaphragm and the other fixed) in the microphone and converting them into electrical waves. These electrical signals are then amplified and picked up by your microcontroller’s ADC.
Electret Mic Breakout Board Hookup Guide
Documents:
- Schematic
- Eagle Files
- Hookup Guide
- Datasheet (OPA344)
- Datasheet (Mic)
- GitHub
Specifiche
Part. No. : | BOB-12758 |
Questions on SparkFun Electret Microphone Breakout
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
709868 Breakout Board for ADMP401 MEMS Microphone
Scheda con microfono MEMS ADMP401 -
712642 Sound Detector
The Sound Detector is a small and very easy to use audio sensing board with three different outputs. The Sound Detector not ofalse -
808649 Electret Microphone Amplifier - MAX9814 with Auto Gain Control
This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on.