Dettagli
This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed.
Note that only one contact will be detected at once (this is to protect against having a hand brush against two or more contacts at once.
Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.
The datasheet has many details on sensitivity, power usage, etc. - note that this board uses the chip in 'standalone' mode only, it cannot be used in I2C mode.
Note that only one contact will be detected at once (this is to protect against having a hand brush against two or more contacts at once.
Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.
The datasheet has many details on sensitivity, power usage, etc. - note that this board uses the chip in 'standalone' mode only, it cannot be used in I2C mode.
Specifiche
Part. No. : | 1362 |
Questions on Standalone 5-Pad Capacitive Touch Sensor Breakout - AT42QT1070 -
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
191129 1129 B - Touch sensor
Sensore capacitivo sensibile al tocco anche attraverso materiali tipo plastica, carta, vetro; con spessori fino a 12mm. Cavo false -
115107 Grove - I2C Touch Sensor
Modulo Grove con 4 sensori touch -
511374 Standalone Momentary Capacitive Touch Sensor Breakout - AT42QT1010
When a capacitive load is detected (e.g. a person touches the sensor-pad area) the red LED lights up and the output pin goes high. -
807653 CAP1188 - 8-Key Capacitive Touch Sensor Breakout - I2C or SPI
Add lots of touch sensors to your next microcontroller project with this easy-to-use 8-channel capacitive touch sensor breakofalse -
712041 AT42QT1010 Capacitive Touch Breakout
The AT42QT1010 Capacitive Touch Breakout offers a single capacitive touch button with easy-to-use digital I/O pins. -
712013 SparkFun Touch Shield
The MPR121QR2 IC is a great way to build simple capacitive touch interfaces, and now it’s even easier to incorporate into youfalse -
714520 SparkFun Capacitive Touch Breakout - AT42QT1011
The AT42QT1011 SparkFun Capacitive Touch Breakout offers a single, momentary capacitive touch button with easy-to-use digitalfalse