This gearmotor is a miniature (0.94" x 0.39" x 0.47"), high-power brushed DC motor with 298:1 metal gearbox, similar to Sanyo’s popular 12 mm gearmotors. These units have a 0.365"-long, 3 mm-diameter D-shaped output shaft.
Key specs at 6 V: 100 RPM and 70 mA free-run, 70 oz-in (5 kg-cm) and 1.6 A stall
These tiny brushed DC gearmotors are intended for use at 6 V, though in general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range (rotation can start at voltages as low as 0.5 V). Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor. The micro metal gearmotors are available in a wide range of gear ratios—from 5:1 up to 1000:1—and offer a choice between three different motors: high-power (HP), medium-power (MP), and standard. With the exception of the 1000:1 gear ratio versions, all of the micro metal gearmotors have the same physical dimensions, so one version can be easily swapped for another if your design requirements change.
The gearbox has a long (0.365" or 9.27 mm), 3 mm-diameter D-shaped metal output shaft, and the brass faceplate has two mounting holes threaded for M1.6 screws (1.6 mm diameter, 0.35 mm thread pitch). The gearmotor weighs approximately 0.35 oz (10 g). Versions with the extended motor shaft have a 1mm diameter round shaft that protrudes 4.5 mm from the rear of the motor, between the two motor terminals; this is not pictured in the above dimension diagram.
|Size:||24 x 10 x 12 mm|
|Shaft diameter:||3 mm|
|Free-run speed @ 6V:||100 rpm|
|Free-run current @ 6V:||70 mA|
|Stall current @ 6V:||1600 mA|
|Stall torque @ 6V:||70 oz·in|
|Extended motor shaft?:||N|
|Part. No. :||994|
Questions on 298:1 Micro Metal Gearmotor HP
No questions asked yetRegister or Login to ask a question.
Excl. Tax:€21.14Incl. Tax:€25.79
Excl. Tax:€21.00Incl. Tax:€25.62
Excl. Tax:€22.00Incl. Tax:€26.84
Excl. Tax:€15.50Incl. Tax:€18.91