3323 - 35STH40 NEMA 14 Bipolar Gearless Stepper
Tutti i prezzi sono IVA inclusa
This NEMA-14 motor generates 1.4 Kg-cm of holding torque at 1 Amp. It comes with the rear shaft exposed, so you can mount anencoder or shaft coupler.
When connected to a 1067 - PhidgetStepper Bipolar HC, the 3323 has a maximum speed of approximately 2340 RPM at zero load.
The 3323 stepper motor connects to a bipolar motor controller such as the 1067 - PhidgetStepper Bipolar HC.
The following table shows how to connect the motor wires to the board connectors to produce a clockwise rotation in the stepper motor when increasing position. To wire for counter-clockwise rotation when increasing position, reverse the red and blue wires.
| Wire Color | Black | Green | Red | Blue |
| Board Connector | A | B | C | D |
Note: Make sure to unplug the power cord from the motor controller before switching wires around.
The rear shaft of this motor can be equipped with the HKT22 Optical Encoder for applications where you need to keep track of the exact position, velocity, or acceleration of the motor.
Motor Properties
| Motor Type | Bipolar Stepper |
| Manufacturer Part Number | 35STH40-1004B |
| Step Angle | 1.8° |
| Step Accuracy | ± 5 % |
| Holding Torque | 1.4 kg·cm |
| Rated Torque | 1.2 kg·cm |
| Maximum Speed (w/1067 Motor Controller) | 2340 RPM |
| Acceleration at Max Speed (w/1067 Motor Controller) |
1E+06 1/16 steps/sec² |
Electrical Properties
| Recommended Voltage | 12 V DC |
| Rated Current | 1 A |
| Coil Resistance | 2.7 Ω |
Physical Properties
| Shaft Diameter | 5 mm |
| Rear Shaft Diameter | 3.9 mm |
| Mounting Plate Size | NEMA - 14 |
| Weight | 200 g |
| Number of Leads | 4 |
| Wire Length | 300 mm |
| Connecting the motor directly to a power supply will destroy the motor and void the warranty. If you want to check your motor make sure it is connected to a constant current / chopper drive controller. |