343786 3786 - 12V, 2.4A Step-Down Voltage Regulator D36V28F12

3786 - 12V, 2.4A Step-Down Voltage Regulator D36V28F12

Piccolo regolatore step-down switching con uscita 12V con potenza da 2.5 a 3.3A in relazione alla tensione di ingresso. Accetta fino a 50V in ingresso.
Prices are VAT included
€13.30 Price
€10.90 + VAT

Qty
 

Details

This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 50 V and efficiently reduces it to 12 V. The board measures only 0.7″ × 0.8″ yet delivers typical maximum continuous output currents between 2 A and 3.3 A, depending on the input voltage, which makes it well suited for powering moderate loads like sensors or small motors. An optional enable input can be used to put the regulator in a low-power state with a current draw of 10 µA to 20 µA per volt on VIN. The regulator also features reverse voltage protection and a power-good output that indicates when the regulator cannot adequately maintain the output voltage. The pins have a 0.1″ spacing, making this board compatible with standard solderless breadboards and perfboards.


The D36V28Fx family of buck (step-down) voltage regulators generates lower output voltages from input voltages as high as 50 V. They are switching regulators (also called switched-mode power supplies (SMPS) or DC-to-DC converters), which makes them much more efficient than linear voltage regulators, especially when the difference between the input and output voltage is large. These regulators can typically support continuous output currents between 2 A and 4 A, depending on the input voltage and output voltage (see the Maximum continuous output current section below). In general, the available output current is a little higher for the lower-voltage versions than it is for the higher-voltage versions, and it decreases as the input voltage increases.

Features

  • Input voltage: 12.9 V to 50 V (minimum input subject to dropout voltage considerations; see the dropout voltage section for details)
  • Output voltage: 12 V with 4% accuracy
  • Typical maximum continuous output current: 2 A to 3.3 A (see the maximum continuous output current graph below)
  • Typical efficiency of 90% to 95%, depending on input voltage, output voltage, and load (see the efficiency graph below)
  • Switching frequency: ~500 kHz under heavy loads
  • Power-save mode with ultrasonic operation that increases light load efficiency by reducing switching frequency, but keeps it above the audible range (20 kHz)
  • 1 mA to 3 mA typical no-load quiescent current (see the quiescent current graph below)
  • Enable input for disconnecting the load and putting the regulator into a low-power state that draws approximately 10 µA to 20 µA per volt on VIN
  • “Power good” output indicates when the regulator cannot adequately maintain the output voltage
  • Output undervoltage and overvoltage protection
  • Soft-start feature limits inrush current and gradually ramps output voltage
  • Integrated reverse-voltage protection up to 40 V, over-current and short-circuit protection, over-temperature shutoff
  • Compact size: 0.7″ × 0.8″ × 0.345″ (17.8 mm × 20.3 mm × 8.8 mm)
  • Two 0.086″ mounting holes for #2 or M2 screws

Dimensions

Size: 0.7″ × 0.8″ × 0.345″1
Weight: 3.3 g1

General specifications

Minimum operating voltage: 12.9 V2
Maximum operating voltage: 50 V
Continuous output current: 2.4 A3
Output voltage: 12 V
Reverse voltage protection?: Y4
Maximum quiescent current: 3 mA5
Output type: fixed 12V

Identifying markings

PCB dev codes: reg24a
Other PCB markings: 0J11946

Notes:

1 Without included optional headers.
2 Subject to dropout voltage considerations. See the dropout voltage graph under the description tab for more information.
3 Typical continuous output current at 36 V in. Actual achievable continuous output current is a function of input voltage and is limited by thermal dissipation. See the otput current graph under the description tab for more information.
4 To -40 V. Connecting supplies over 40 V in reverse can damage the device.
5 While enabled with no load. Can be reduced to under 1 mA using the enable pin.

File downloads

Dimension diagram of the Step-Down Voltage Regulator D36V28Fx (306k pdf)
3D model of the Step-Down Voltage Regulator D36V28Fx (5MB step)
Drill guide for the Step-Down Voltage Regulator D36V28Fx (31k dxf)
This DXF drawing shows the locations of all of the board’s holes.

Specifications

Part. No. : 3786

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Questions on 3786 - 12V, 2.4A Step-Down Voltage Regulator D36V28F12

No questions asked yet

Register or Login to ask a question.
Register or Login to ask a question.
  1. 2119 - Pololu Step-Up/Step-Down Voltage Regulator S7V7F5

    582119 2119 - Pololu Step-Up/Step-Down Voltage Regulator S7V7F5

    The S7V7F5 switching step-up/step-down regulator efficiently produces 5 V from input voltages between 2.7 and 11.8 V. Its abifalse
    Excl. Tax:
    €4.18
    Incl. Tax:
    €5.10
      Compare
  2. 2868 - 2.5-9V Fine-Adjust Step-Up/Step-Down Voltage Regulator w/ Adjustable Low-Voltage Cutoff S9V11MACMA

    342868 2868 - 2.5-9V Fine-Adjust Step-Up/Step-Down Voltage Regulator w/ Adjustable Low-Voltage Cutoff S9V11MACMA

    The S9V11MACMA switching step-up/step-down regulator efficiently produces a finely adjustable output between 2.5 V and 9 V whfalse
    Excl. Tax:
    €8.92
    Incl. Tax:
    €10.88
      Compare
  3. 2870 - 5V Step-Up/Step-Down Voltage Regulator w/ Adjustable Low-Voltage Cutoff S9V11F5S6CMA

    342870 2870 - 5V Step-Up/Step-Down Voltage Regulator w/ Adjustable Low-Voltage Cutoff S9V11F5S6CMA

    The S9V11F5S6CMA switching step-up/step-down regulator efficiently produces a fixed 5 V (default) or 6 V (selectable) output false
    Excl. Tax:
    €6.74
    Incl. Tax:
    €8.22
      Compare
  4. 2869 - 5V Step-Up/Step-Down Voltage Regulator w/ Adjustable Low-Voltage Cutoff S9V11F5S6CMA

    342869 2869 - 5V Step-Up/Step-Down Voltage Regulator w/ Adjustable Low-Voltage Cutoff S9V11F5S6CMA

    The S9V11MA switching step-up/step-down regulator efficiently produces a finely adjustable output between 2.5 V and 9 V whethfalse
    Excl. Tax:
    €6.74
    Incl. Tax:
    €8.22
      Compare
  5. 3782 - 5V, 3.2A Step-Down Voltage Regulator D36V28F5

    343782 3782 - 5V, 3.2A Step-Down Voltage Regulator D36V28F5

    Piccolo regolatore step-down switching con uscita 5V con potenza da 2.5 a 4A in relazione alla tensione di ingresso. Accetta false
    Excl. Tax:
    €10.90
    Incl. Tax:
    €13.30
      Compare
  6. 3781 - 3.3V, 3.6A Step-Down Voltage Regulator D36V28F3

    343781 3781 - 3.3V, 3.6A Step-Down Voltage Regulator D36V28F3

    Piccolo regolatore step-down switching con uscita 3.3V con potenza da 3.2 a 4.5A in relazione alla tensione di ingresso. Accefalse
    Excl. Tax:
    €10.90
    Incl. Tax:
    €13.30
      Compare

Price Match



* Required Fields