Details
The GP-2106 is a small form factor GPS module with built-in antenna. Powered by the SiRF Star IV, the module can acquire satellites as low as -163dBm. It also has a hibernate mode which can go as low as 30uA while maintaining a hot start.
Note: This module runs at 1.8V VCC, however, you can use 3.3V TTL on the TX and RX pins. Also, the ON/OFF pin needs to be toggled high (to 1.8V) or low in order to turn on the module.
Features:
- SiRF IV chipset (3db gain over SiRF III)
- 48 channel
- Cold start - 35 second
- Warm start - 35 second
- Hot start - 1 second
- 1Hz update rate
- 1.8VCC input
- 4800bps (default)
Documents:
Questions on 48 Channel GP-2106 SiRF IV GPS Receiver
No questions asked yet
Register or Login to ask a question.Related Products
-
709914 JST Jumper 2 Wire Assembly
This is a simple two wire cable. Great for jumping from board to board or just about anything else. -
710359 JST SH Jumper 4 Wire Assembly - 8
This is a simple 4 wire cable. Great for jumping from board to board or just about anything else. -
710361 JST SH Jumper 6 Wire Assembly - 8
This is a simple 6 wire cable. Great for jumping from board to board or just about anything else. -
708671 Jumper Wire - JST Black Blue
This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the oppfalse -
708670 Jumper Wire - JST Black Red
This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the oppfalse -
708599 Jumper Wire - JST to Female Connector
This is a simple two wire cable. One end has a 2 pin female 0.1" pitch connector. Opposite end has 2-pin JST connector. -
708598 Jumper Wire - JST to Molex
This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, 2-pin Molex 0.1"false -
709916 JST Jumper 4 Wire Assembly
This is a simple 4 wire cable. Great for jumping from board to board or just about anything else. -
709915 JST Jumper 3 Wire Assembly
This is a simple 3 wire cable. Great for jumping from board to board or just about anything else. -
710896 Interface Cable - GP-2106
This 6-conductor ribbon cable mates with the connector on the bottom of the GP-2106 GPS module. 70mm length