Details
This AutoDriver makes it easy to put the L6470 Stepper Driver (a.k.a "dSPIN") to work in your project. Simply connect your motors and your SPI-capable microcontroller and get steppin'!
STMicro's L6470 is a 3A, 8-45V bipolar stepper motor driver. It has built-in overcurrent detection, undervoltage detection, overtemperature detection, stall detection, a 5-bit ADC, and a switch input that can be used for either user jog control or as a hard stop function. As if that weren't enough, it also features microstepping support (up to 128 microsteps per full step) and PWM drive voltage limiting.
Unlike most stepper motor drivers, the dSPIN is controlled over an SPI link. It has an on-board 16MHz oscillator which allows it to autonomously execute movement commands. That means no more counting steps in your code! It also supports customized acceleration and deceleration profiles to prevent jerky starts and stops. On-board registers track current speed and location.
- Supports up to 128 Microsteps per Full Step
- Over-Temperature Detect
- Over-Current Detect
- Under-Voltage Detect
- PWM Drive-Voltage Limiting
- SPI Controlled
- On-Board Oscillator and Speed/Location Registers
- Stall Detection
- 5-bit ADC
- Schematic
- Eagle Files
- Datasheet (L6470 dSPIN)
- AutoDriver Library
- GitHub
Specifications
Part. No. : | BOB-11611 |
Questions on AutoDriver - Stepper Motor Controller
No questions asked yet
Register or Login to ask a question.Related Products
-
709238 Stepper Motor with cable
This is a simple, but very powerful stepper motor with a 4-wire cable attached. -
710846 Stepper Motor - NEMA-17 - 48mm - 42BYGHM809
Stepper, NEMA17 form-factor. Length:48mm shaft escluded. Holding Torque: 58oz.in -
710848 Stepper Motor - 29 oz.in (200 steps/rev, Threaded Shaft)
These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along thfalse -
342268 Stepper Motor with 28cm Lead Screw: Bipolar, 200 Steps/Rev, 2.8V, 1.7 A/Phase
This NEMA 23-size hybrid stepping motor can be used as a unipolar or bipolar stepper motor and has a 1.8° step angle (200 stefalse