Details
This a simple breakout board for the button pads. Each LED and button is brought out to the side connectors. The connectors are soldered to the back side of the PCB. We recommend trimming the connector leads on the button side as short as possible to reduce the deflection of the pad.
Now with footprints for diodes! Use the super cheap 1N4148 through hole diodes. These can be used to isolate the switches to make for a bit easier decoding.
Documents:
Questions on Button Pad 4x4 - Breakout PCB
No questions asked yet
Register or Login to ask a question.Related Products
-
707836 Button Pad 2x2 - LED Compatible
This is a translucent silicon rubber button pad with 4 buttons orignally inspired by the folks at monome.org. -
708746 Button Pad 2x2 Top Bezel
This is a black plastic bezel, custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. -
708747 Button Pad 2x2 Bottom Bezel
This is a black plastic bezel, custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. -
709277 Button Pad 2x2 - Breakout PCB
This a simple breakout board for the button pads. Each LED and button is brought out to the side connectors. The connectors afalse -
700105 LED - RGB Clear Common Cathode
These 5mm units have four pins - Cathode is the longest pin. One for each color and a common cathode. Use this one LED for thfalse -
707835 Button Pad 4x4 - LED Compatible
This is a translucent silicon rubber button pad with 16 buttons originally inspired by the folks at monome.org.