Motori

Description: This is a simple, but very powerful stepper motor with a 4-wire cable attached. This is a Bipolar Motor. Features: Step Angle (degree...

This gearmotor is a miniature (0.94" x 0.39" x 0.47"), high-power brushed DC motor with 298:1 metal gearbox, similar to Sanyo’s popular 12 mm gearm...

These small steppers are a great way to get things moving, especially when positioning and repeatability is a concern. This is a Bipolar motor. Fea...

This tiny board is an easy way to use Toshiba’s TB6612FNG dual motor driver, which can independently control two bidirectional DC motors or one bip...

The HS-81 and HS-81MG are among Hitec?s most popular servos. Available in both resin and metal gear versions. With a fine balance between speed and...

This is the motor you want if you are looking for a low cost unipolar stepper that needs to do some work. Motor Controller and Connection The 3314...

This coated steel mounting bracket provides a simple means of attaching a NEMA-17 sized stepper motor to a flat surface. It has two sets of mountin...

  Hitec HS-430BH is the substitute of HS-425 and is designed to work up to 7.4V, than is the perfect choice if you want to use 2 LiPo cells. Techni...

  This hybrid stepping motor can be used as a unipolar or bipolar stepper motor and has a 1.8° step angle (200 steps/revolution). Each phase draws ...

This tiny breakout board for TI’s DRV8838 motor driver can deliver a continuous 1.7 A (1.8 A peak) to a single brushed DC motor. With an operating...

The 5485HB is the latest addition to the Hitec digital line of servos offering improved performance over the 5475HB for even less money! The HS-54...

These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific ...

  This gearmotor is a miniature (0.94" x 0.39" x 0.47"), high-quality, high-power motor with 50:1 metal gearbox, similar to Sanyo’s popular 12 mm g...

  This gearmotor is a miniature (0.94" x 0.39" x 0.47"), high-quality, high-power motor with 30:1 metal gearbox, similar to Sanyo’s popular 12 mm g...

The EGM30 (encoder, motor, gearbox 30:1) is a 12v motor fully equipped with encoders and a 30:1 reduction gearbox. It is ideal for small or medi...

This coated steel mounting bracket provides a simple means of attaching a NEMA-11 sized stepper motor to a flat surface. It has two sets of mountin...

This gearmotor is a miniature (0.94" x 0.39" x 0.47"), high-power brushed DC motor with 75.81:1 metal gearbox, similar to Sanyo’s popular 12 mm gea...

This NEMA-23 motor generates 12 kg-cm of torque at 2.8 Amps. It comes with the rear shaft exposed, so you can mount an encoder or shaft coupler. Th...

A4983 driver can control stepper motors and have two channels. The board can also power gear motors. It might be supplied by voltage in the 6V to 3...

This NEMA-11 motor generates 600 g-cm of holding torque at 0.67 Amps. It comes with the rear shaft exposed, so you can mount anencoder or shaft cou...