Details
EMG detector is a bridge connects human body and electrical, the sensor gathers small muscle signal then process with 2th amplify and filter, the output signal can be recognized by Arduino. You can add this signal into your control system. Note: The sensor cannot be used for medical purposes.
In standby mode, the output voltage is 1.5V. When detect muscle active, the output signal rise up, the maximum voltage is 3.3V. You can use this sensor in 3.3V or 5V system.
Features:
- Grove Compatible
- 3.5mm Connector
- 6 Disposable Surface Electrodes
- Power supply voltage: 3.3V-5V
- 1000mm Cable Leads
- No additional power supply
Move
When finish downloading demo code, it'll take about 5s to initialize, you should keep static when initializing.
You can see that when initializing, the Led Bar will go form level 10 to level 0. When Led Bar All off, you can move now.
When you are moving, you can find that the level of Led Bar will change.
Resource
Documents
Specifications
Part. No. : | 811006001 |
Interface : | n/a |
Voltage : | 5 |
Related Products
-
115124 Grove - Universal 4 Pin Buckled 30cm Cable (5 PCs Pack)
The Universal 4 Pin Buckled Cable is made for the Grove System to connect all of the Twigs to the Stem - Basic Shield or to ofalse -
500221 SHIELD-EKG-EMG - ELECTROCARDIOGRAPHY ELECTROMYOGRAPHY SHIELD
This is an EKG/EMG shield which allows Arduino like boards to capture Electrocardiography Electromiography signals. -
500222 SHIELD-EKG-EMG-PA - PASSIVE ELECTRODES FOR ELECTROCARDIOGRAPHY ELECTROMIOGRAPHY SHIELDS
This is a passive electrode for a SHIELD-EKG-EMG shield which allows Arduino like boards to capture Electrocardiography Electfalse