Details
This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.
The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.
Features:
- 10-bit DAC for good accuracy
- 2 frequency registers
- 2 phase registers
- SPI Interface Driven at 40MHz
- Operating Voltage: 3.3V (5V when jumper is soldered)
Documents:
- Schematic
- Eagle Files
- Hookup Guide
- Datasheet (AD8045)
- Datasheet (AD9837)
- GitHub (Arduino Library, Example Code, & Design Files)
Specifications
Part. No. : | BOB-11420 |
Questions on MiniGen - Pro Mini Signal Generator Shield
No questions asked yet
Register or Login to ask a question.Related Products
-
700662 Interface Cable RP-SMA to U.FL
This connector cable interfaces UFL RF connectors to RP-SMA antennas. -
709145 Interface Cable SMA to U.FL
This is a 4" connector cable that interfaces U.FL RF connectors to regular SMA connections. -
711113 Arduino Pro Mini 328 - 5V/16MHz
SparkFun's minimal design approach to Arduino. This is a 5V Arduino running the 16MHz bootloader (select 'Arduino Duemilanovefalse