Now mounted on a breakout board, the MPL115A1 is a digital barometric pressure sensor that uses MEMs technology to give accurate pressure measurements between 50kPa and 115kPa. We stock the SPI interface version of the sensor. Average current consumption is 10µA at one measurement per second.
The sensor outputs both temperature and pressure readings on the SPI bus. See page 3 of the datasheet for information on how to take readings from the pressure sensor.
- Wide supply voltage range
- -40°C to 105°C maximum temperature range
- Low power consumption
- kPa accuracy
5x3 mm (1.2mm height)
Questions on MPL115A1 Barometric Pressure Sensor Breakout
No questions asked yetRegister or Login to ask a question.
710121 IMU Digital Combo Board - 6 Degrees of Freedom ITG3200/ADXL345This is a simple breakout for the ADXL345 accelerometer and the ITG-3200 gyro. With this board, you get a full 6 degrees of ffalseExcl. Tax:€32.05Incl. Tax:€39.10
711084 MPL3115A2 Altitude/Pressure Sensor BreakoutThe MPL3115A2 is a MEMS pressure sensor that provides Altitude data to within 30cm (with oversampling enabled). The sensor oufalseExcl. Tax:€12.17Incl. Tax:€14.85
712039 T5403 Barometric Sensor BreakoutThis is the T5403 breakout board, a fully calibrated barometric pressure sensor with an I2C interface. The T5403 sensor measufalseExcl. Tax:€12.17Incl. Tax:€14.85
809286 Adafruit MPRLS Ported Pressure Sensor Breakout - 0 to 25 PSISensore di pressione con presa aria. Si puo' collegare un tubetto alla presa per misurare la pressione dell'aria. Comunica trfalseExcl. Tax:€16.50Incl. Tax:€20.13