The MuIn is a versatile Multi Interface Board. It is useful in many applications: robotics, automation, control, development, etc. The board is equipped with a powerful PIC18F2520 running at 40MHz It comes preloaded with a bootloader*, for serial programming and upgrading, and a firmware* full of features.
The MuIn can drive two H-Bridges with two PWM channels and two enable I/O. It can read up to five analogical devices such as temperature sensors, potentiometers, distance sensors, etc; with a 10Bit resolution. With Port B it can drive 4/8 R/C servos or it can read or write 4/8 I/O ports. With the I2C bus you can control almost any I2C devices, sending the commands through the serial connection. With special commands you can easily read almost all of the Devantech I2C sensor and devices and with the free GUI* (Graphical User Interface) you can program the device ID with a mouse click.
There are several ways to send and receive data to and from the MuIn, thanks to its socket you can use an XBee module to make a ZigBee connection, with an XPort module (the 990.007 adapter is needed) you can make an Ethernet connection, you can talk to the MuIn through the Internet or a LAN. With our 990.004 USB to Serial converter, you can easily connect the MuIn to your PC USB port.
Last but not least, the firmware is made to be compatible with the free version of the Microchip C18 compiler and it is Open Source (for non commercial use).
You can also use the MuIn 990005 as a powerful development board for the PIC18F2520.
- MCU: Microchip PIC18F2520
- 5.0V Power: 250mA
- 3.3V Power 250mA
- Servo: 500 to 2500 us
- PWM: 2.44/9.77/39.4KHz selectable
- Serial Speed: up to 115.2K selectable
- Dimensions: 52 x 68 mm
- Powerful 40MHz PIC18 MCU
- Wireless, Ethernet, USB, TTL data connections (w/optional devices)
- Serial to I2C interface
- Serial to I2C Devantech devices interface
- 3.3V and 5.0V on board low drop out voltage regulators
- High PWM frequency, up to 39.4KHz
- High Serial Speed up to 115.2K
- 3 LED’s for: ASSOC, RSSI and MCU status
- On board ICSP connector
- Power and Ground headers
- Power line selectable
- Servo Power Connector
- Open Source Code
- Free Graphical Interface
The Graphical Interface (GUI)
The preloaded software and the free GUI is just for demonstration purposes we do not give any warranty. The firmware is open source you are free to modify it and use for studying, learning and testing the capabilities of the MuIn Board. We will be very happy if anyone will share their software with other Users on our Forum: www.robot-italy.net For any question or help with the firmware and the GUI, ask to our Forum, we do not provide direct support on software.
*The bootloader has been tested with our 990.004 USB to serial converter. It may not works with other configurations. The best way to program the board is a good PIC Programmer.
.JPG - Scheme(260KB)
for updates look at our Forum
Questions on MuIn - Multi Interface Board with PIC18F2520
No questions asked yetRegister or Login to ask a question.
Excl. Tax:€19.10Incl. Tax:€23.30