Details
The MyoWare Power Shield is designed to take two standard CR2032 coin cell batteries to power the MyoWare Muscle Sensor. We have made this board in a way that the coin cell batteries are connected in parallel for extended capacity at a nominal 3.0V. Connecting the MyoWare Muscle Sensor to battery power allows for a cleaner signal while also eliminating the possibility of creating a dangerous current path to the power grid.
One thing to note is that due to the size of the batteries, the remote cable header on the MyoWare Miscle Sensor can’t be passed through. If you need access to these connections, this Power Shield will need to be stacked above the board(s) that need access.
The MyoWare Muscle Sensor, that this shield attaches to, is an Arduino-powered, all-in-one electromyography (EMG) sensor from Advancer Technologies. The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle; outputting 0-Vs Volts depending the amount of activity in the selected muscle, where Vs signifies the voltage of the power source.
Documents:
Specifications
Part. No. : | DEV-13684 |
Related Products
-
712969 Biomedical Sensor Pad (10 pack)
This is a 10 pack of Biomedical Sensor Pads, disposable electrodes that can be used to measure EEG, ECG and EMG levels. thesefalse -
713723 MyoWare Muscle Sensor
The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle; outputting 0-Vs Volts dependifalse -
713709 MyoWare Proto Shield
With this shield you will be able to use the area provided to solder on whatever custom circuitry you can come up with. This false -
713688 MyoWare LED Shield
The MyoWare LED Shield is designed to pair with the MyoWare Muscle Sensor. The blue 10-segment bar graph shows the magnitude false -
713959 Ultrasonic Sensor - HC-SR04
This is the HC-SR04 ultrasonic ranging sensor. This economical sensor provides 2cm to 400cm of non-contact measurement functifalse -
714109 MyoWare Cable Shield
Shield per il sensore muscolare Myoware, estende i sensori tramite un jack da 3.5mm. Consente di utilizzare il Myoware a distanza