This is the motor you want if you are looking for a low cost unipolar stepper that needs to do some work.
Motor Controller and Connection
The 3314 stepper motor connects to:
The following table shows how to connect the motor wires to the 1062 board connectors to get clockwise rotation. To wire for counter-clockwise rotation, swap the Black and Blue wires.
To connect the motor to the 1063, leave out the two Red wires.
Note: Make sure to unplug the power cord from the controller board before switching wires around.
- Good Torque
- Step angle: 7.5°
- Holding Torque: 950 g-cm @ 0.28 Amp
|Holding Torque||950 g-cm / 13.19 oz-in|
|Number of Leads||6|
|Shaft Diam. mm :||3|
Questions on PM42L-048-17 950g-cm Unipolar Stepper
No questions asked yetRegister or Login to ask a question.