Dettagli
Extend your light-sensing spectrum with this analog UV sensor module. It uses a UV photodiode, which can detect the 240-370nm range of light (which covers UVB and most of UVA spectrum). The signal level from the photodiode is very small, in the nano-ampere level, so we tossed on an opamp to amplify the signal to a more manageable volt-level.
This sensor is much simpler than our Si1145 breakout, it only does one thing and gives an analog voltage output instead of requiring a complicated I2C setup procedure. This makes is better for simple projects. It also has a 'true' UV sensor instead of a calibrated light-sensor. To use, power the sensor and op-amp by connecting V+ to 2.7-5.5VDC and GND to power ground. Then read the analog signal from the OUT pin. The output voltage is: Vo = 4.3 * Diode-Current-in-uA. So if the photocurrent is 1uA (9 mW/cm^2), the output voltage is 4.3V. You can also convert the voltage to UV Index by dividing the output voltage by 0.1V. So if the output voltage is 0.5V, the UV Index is about 5.
Please note, our UV LEDs are 400nm, outside the range of this sensor, so if you're trying to test this sensor, don't use them! A UV tanning lamp or 'lizard-lamp' will work much better.
-
Details:
- Datasheet
- Dimensions: 10mm x 19mm x 2mm / 0.4" x 0.75" x 0.08"
- Weight: 0.7g
Specifiche
Part. No. : | 1918 |
Questions on Analog UV Light Sensor Breakout - GUVA-S12SD
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
809285 Adafruit VEML6075 UVA UVB and UV Index Sensor Breakout
Questo modulo basato sul chip VEML6075 ha due sensori, uno per la banda UVA e uno per UVB. Lavora sia a 3 che 5V e comunica cfalse -
809286 Adafruit MPRLS Ported Pressure Sensor Breakout - 0 to 25 PSI
Sensore di pressione con presa aria. Si puo' collegare un tubetto alla presa per misurare la pressione dell'aria. Comunica trfalse