Dettagli
The PowerTap is tiny (less than 1” square) accessory board for simplifying the hookup of power on long runs of LEDs. Due to voltage drops over long strips, it is recommended to inject power every 5m or 5A, whichever comes first. With the PowerTap, you can build in a quick connect/disconnect power port in between your sections of LEDs. Very basic soldering skills required to assemble the board.
Features:
- 2.1mm DC barrel jack for input of 5-12V @ up to 5A
- Input and output 0.1” spacing screw terminals. Data, Clock, and Ground are carried along to the other side while power is only sent to the output terminal to the next section of LEDs
- 1000uF capacitor for smoothing out power fluctuations
Part List:
- PowerTap board
- 2.1mm DC barrel jack
- 2x 0.1” screw terminal
- 1000uF Capacitor
If you have any questions, feel free to send us an email to service.
For any technical support or suggestion, please kindly go to our forum.
- See more at: http://www.robot-italy.com/it/allpixel-kit.html#sthash.5wVqwiQd.dpuf
Specifiche
Part. No. : | 110060062 |
Questions on AllPixel Power Tap Kit
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
808348 AllPixel Kit
The AllPixel is a small (2.7" x 0.9"), device that provides easy USB control of all the major programmable LED strifalse