Dettagli
Bus Pirate v3 is a universal bus interface that talks to electronics from a PC serial terminal. Get to know a chip without writing code. Eliminates a ton of early prototyping effort with new or unknown chips.
Protocols
1-Wire, I2C, SPI, JTAG, asynchronous serial (UART), MIDI, PC keyboard, HD44780 LCDs, and generic 2- and 3-wire libraries for custom protocols.
Features
- USB interface, USB powered
- 5volt tolerant pins
- 0-6volt measurement probe
- 1Hz-40MHz frequency measurement
- 1kHz-4MHz pulse-width modulator, frequency generator
- On-board multi-voltage pull-up resistors
- On-board 3.3volt and 5volt power supplies with software reset
- Macros for common operations
- Bus traffic sniffers (SPI, I2C)
- Transparent USB to serial bridge mode
- 10Hz-1MHz low-speed logic analyzer
- Custom support in AVRDUDE , Flashrom , OpenOCD
- AVR STK500 v2 programmer clone
- Scriptable from Perl, Python, etc.
- A bootloader for easy USB firmware updates
- Uses DP6037 standard PCB layout
- Open source (CC 0/Public Domain)
Support
If you encounter any problems when using this product, here is the forum from which you can get the technical support.
Specifiche
Part. No. : | 102990038 |
Questions on Bus Pirate v3.6 universal serial interface
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
808230 Bus Pirate v4
Bus Pirate v4 is a universal bus interface that talks to electronics from a computer serial terminal. Get to know a chip withfalse -
808231 Logic Pirate
The Logic Pirate is an inexpensive, yet capable open source logic analyzer. It can sample 8 channels at 20 million samples pefalse -
712942 Bus Pirate - v3.6a
The Bus Pirate v3.6a, created by Ian Lesnet, is a troubleshooting tool that communicates between a PC and any embedded devicefalse -
120070 Multi USB/RS232/RS485/TTL Converter
Multiplexer has a set of interfaces for a variety of multi-function adapter plates. It supports USB, TTL, RS232, RS485 interffalse -
715033 USB Logic Analyzer - 25MHz/8-Channel
Analizzatore logico USB a 8 canali. Lavora a 3.3 e 5V, alimentato dalla porta USB. Analizza SPI, I2C, UART, etc