500072 LPC-P2103 PROTOTYPE BOARD FOR LPC2103 ARM MICROCONTROLLER

• MCU: LPC2103 ARM7TDMI-S 32-BIT, up to 70Mhz
  
• FLASH: 32KB
  
• RAM: 8 KB
  
• UART: x2
  
• SPI: 1 - 7.5 Mbit/sec.
  
• SSP: 1 - 30 Mbit/sec
  
• I2C: x2
  
• ADC: x8 CH, 10-BIT, 400 Ksps
  
• PWM: x12
  
• TMR: x2 16-BIT, x2 32-BIT
  
• RTC: 1
  
• I/O: Up to 32, 5V tolerant
  
• operating temperature: -40+85C
  

BOARD FEATURES:

• MCU: LPC2103 16/32 bit ARM7TDMI-Sâ„¢ with 32K Bytes Program Flash, 8K Bytes RAM, RTC, 2x UARTs, 2x I2C, SPI, 5x 32bit TIMERS, 8x 10bit ADC, CCR, PWM, WDT, 5V tolerant I/O, up to 70MHz operation
• ARM JTAG 2x10 pin connector
• extension header for uC pins
• 14.7456 Mhz crystal allow easy communication setup (4x PLL = 58,9824 Mhz CPU clock)
• 32768 Hz crystal
• RS232 interface circuit
• user button
• status LED
• power supply LED
• RTC backup Li-ion battery
• RESET circuit
• RESET button
• DEBUG jumper for JTAG enable/disable
• BSL jumper for bootloader enable/disable
• RTCK pullup resistor
• push BUTTON with pullup
• Power plug-in jack
• single power supply: +6VAC or 9VDC
• two on board voltage regulators 1.8V and 3.3V with up to 800mA current
• power supply filtering capacitor
• UEXT universal extension connector
• PCB: FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print
• prototype PCB area with +3.3V and GND bus
• Dimensions: 100x80 mm (3.9x3.15")
• Four mounting holes

DOCUMENTS:

• LPC-P2103.pdf

• LPC-P2103 schematic
• ARM JTAG connector (TOP view)

• LPC2103 demo code project for EW-ARM
• LPC2103 blink example under Linux by Benedikt Sauter
• OpenOCD + Eclipse set of projects 1.00 include flash write make file for LPC-H2103. The complete list of projects included is here.