Dettagli
L'RFID USB Reader e' semplice da usare. Basta inserire uno dei moduli della ID Innovations: ID-2, ID-12, e ID-20 e collegare la porta USB al computer (installare i drivers). Utilizzando un programma terminale a 9600bps 8N1 e avvicinando un TAG a 125kHz , l'ID del TAG apparira' sullo schermo. Il modulo e' basato sul chip FTDI USB ed e' dotato di un LED ed un Buzzer che segnalano la corretta lettura del TAG RFID.
Questa nuova versione ha un jumper a saldare che permette di disabilitare il buzzer e il connettore per il modulo di lettura è in formato SMD
NOTA: Il modulo RFID reader non e' fornito, va acquistato a parte (vedi i prodotti correlati).
Dimensioni: 1.4x1.2x0.57"
Documenti:
Codice Sparkfun : SEN09963
Questions on RFID USB Reader
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
316004 MOD-RFID125 Reader RFID USB per Tags a 125KHz
Lettore RFID USB per Tags a 125KHz, emulazione tastiera e RS232 -
316005 MOD-RFID125-BOX Reader RFID USB per Tags a 125KHz in Box
Lettore RFID USB per Tags a 125KHz, emulazione tastiera e RS232, in Box -
711828 RFID Reader ID-20LA (125 kHz)
This is the ID-20LA, a very simple to use RFID reader module from ID Innovations. With a built in antenna, the only holdup isfalse -
711827 RFID Reader ID-12LA (125 kHz)
This is the ID-12LA, a very simple to use RFID reader module from ID Innovations. With a built in antenna, the only holdup isfalse -
711862 RFID Reader ID-3LA (125 kHz)
This is the ID-3LA, a very simple to use RFID reader module from ID Innovations. The only holdups are the 2mm pin spacing andfalse -
713198 SparkFun RFID Starter Kit
This it the SparkFun RFID Starter Kit, an all-in-one kit that offer everything you need to get your next RFID project off thefalse -
714066 SparkFun Simultaneous RFID Reader - M6E Nano
Lettore/Scrittore di TAG RFID basato sul reader M6E Nano, utilizzabile come Shield Arduino