Dettagli
These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific rate of 1cm per 5 full rotations. These are a good choice for linear motion where precision and repeatability are important.
Note: It looks like the datasheet for this stepper may not be accurate. When connecting this motor to a bi-polar driver you'll want to wire it according to the wiring diagram in the documents below.
Features:
- Step Distance: 0.01mm
- 2-Phase
- Rated Voltage: 12V
- Rated Current: 0.4A/Phase
- 100mm Long Threaded Shaft (keyed on one end)
- Holding Torque: 21 N.cm
- 6-Pin Wiring Harness Included
Documents:
Specifiche
Part. No. : | ROB-10848 |
NEMA : | 15 |
WINDING : | Bipolar |
Questions on Stepper Motor - 29 oz.in (200 steps/rev, Threaded Shaft)
No questions asked yet
Fai una domanda (Registrati oppure Esegui il Login ).Prodotti correlati
-
709238 Stepper Motor with cable
This is a simple, but very powerful stepper motor with a 4-wire cable attached. -
711611 AutoDriver - Stepper Motor Controller
Motor Controller per motori Passo Passo bipolari, basato sul chip L6470. Si pilota con protocollo SPIPrezzo di listino:€ 34,25OffertaTasse escluse:€ 23,00IVA inclusa:€ 28,06Prezzo IVA incl.
Confronta -
712859 Big Easy Driver
The Big Easy Driver, designed by Brian Schmalz, is a stepper motor driver board for bi-polar stepper motors up to a max 2A/phase. -
713118 SparkFun Servo Trigger
When an external switch or logic signal changes state, the Servo Trigger is able to tell an attached servo motor to move fromfalse