If you have a modern smart phone you may have noticed that it comes with built in wireless charging capability called 'Qi charging.' Qi is a trademark name for a thin and smart inductive charging system. Many large gadget companies have standardized on Qi, which means it's easy to find a charging dish and we thought it might be cool if your Arduino project can recharge itself wirelessly. Thus, we now have a Qi charging receiver module as seen here here.
This is just the inductive charging Qi receiver. It will work with any Qi charger base transmitter that will work well with any standard inductive charger base. Simply solder two wires to the V+ and Gnd pins on the Qi module and place the item you want charged onto a charging base. The receiver chip manages the coil so that you'll always get 5V and 500mA. If the coil is too far it will simply not activate at all. In our demo, we used a classic cell phone charger plate
The driver chip is an integrated receiver called the BQ51053B from TI. Since its a Qi charger it can only be used with Qi transmitters!
To demo it, we wired the module to a MiniLipo charger and a LiPo battery, as shown in the photos. Now we have a wirelessly-rechargeable battery! Note that you don't get the battery or lipo charger in your order, that's just how we're showing it off. You can even upgrade any device that takes classic USB 5V and up to 500mA. The coil comes on a metallic sticker which is used to shield the device from the coil. Make sure the coil is facing out towards the charger when you install it into your project, or it wont work at all!
- Output Voltage: 4.8V - 5.2V
- Current: 500mA
- Operating Temperature: -40ºC ~ 40ºC
- Back Panel: 48mm x 32mm x 0.5mm / 1.9" x 1.3" x 0.02"
- Chip: 11.5mm x 36mm x 0.3mm / 0.5" x 1.4" x 0.01"
- Copper Coil: 41mm x 29mm / 1.6" x 1.1"
- Weight: 4.7g
|Part. No. :||1901|
Questions on Universal Qi Wireless Receiver Module
No questions asked yetFai una domanda (Registrati oppure Esegui il Login ).
808025 Universal Qi Wireless Charging TransmitterConnect the board to a 5v power supply - either through a micro USB port - then put your device w/ Qi receive onto the base. falseTasse escluse:€ 35,79IVA inclusa:€ 43,66
808887 Inductive Charging Set - 3.3V @ 500mA maxThis is a basic charger set, and it does work, providing 3.3V DC output from the output half when the input half is powered wfalseTasse escluse:€ 9,48IVA inclusa:€ 11,57
808916 Adafruit TPL5110 Low Power Timer BreakoutThe Adafruit TPL5110 Power Timer is a stand-alone breakout that will turn any electronics into low-power electronics! It willfalseTasse escluse:€ 6,00IVA inclusa:€ 7,32