The USB-RLY08B provides eight volt free contact relay outputs with a current rating of up to 1Amp each. It is powered from any standard USB bus and has an exceptionally low maximum current consumption of approx. 90mA with all relays on. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed and common pins are all available on the screw terminals.
The USB-RLY08B provides a red LED mounted immediately next to each relay to indicate whether it is in a powered state (LED on), there is also two LED's which will flash with USB transactions to and from the module, green indicating reception of data from the PC and yellow the transmission of data to the PC. Finally there is red power LED mounted on the opposite side of the board to the USB connector.
Relay power rating
If the contact load voltage and current of the relay are in the region enclosed by the solid and dotted lines in the figure below, the relay can perform stable switching operation. If the relay is used at a voltage or current exceeding this region, the life of the contacts may be significantly shortened.
The USB-RLY08B operates with an easy to use command set as described in the table below. Most commands are only a single byte and if applicable the USB-RLY08B will automatically send its response. The only exception to this being the "Set relay states" command which requires and additional desired states byte to be sent immediately after the command byte.
|90||5A||Get software version - returns 2 bytes, the first being the Module ID which is 8, followed by the software version|
Get relay states - sends a single byte back to the controller, bit high meaning the corresponding relay is powered
|92||5C||Set relay states - the next single byte will set all relays states, All on = 255 (11111111) All off = 0|
|100||64||All relays on|
|101||65||Turn relay 1 on|
|102||66||Turn relay 2 on|
|103||67||Turn relay 3 on|
|104||68||Turn relay 4 on|
|105||69||Turn relay 5 on|
|106||6A||Turn relay 6 on|
|107||6B||Turn relay 7 on|
|108||6C||Turn relay 8 on|
|110||6E||All relays off|
|111||6F||Turn relay 1 off|
|112||70||Turn relay 2 off|
|113||71||Turn relay 3 off|
|114||72||Turn relay 4 off|
|115||73||Turn relay 5 off|
|116||74||Turn relay 6 off|
|117||75||Turn relay 7 off|
|118||76||Turn relay 8 off|
Visual studio express C# examples
The test program is available as Visual C# express ready built installation files here, or as Visual C# express project with source files here.
Visual studio express is provided free from Microsoft: http://www.microsoft.com/exPress/download/
|Part. No. :||USB-RLY08-B|
Questions on USB-RLY08-B - 8 channel USB relay
03/02/18 16.50 Dalle istruzioni allegate si capisce che è possibile accedere ad una uscita alla volta inviando un comando in dec o hex. e che tutte e uscite sono attivabili contemporaneamente inviando il n 255. Vorrei sapere però se il dispositivo può attivare contemporaneamente più uscite ed in quale modo.
- 15/02/18 13.38 salve. una domanda è possibile integrarlo in un progetto in NODEJS ?