The WIFI484 provides four volt free contact relay outputs with a current rating of up to 16Amp each, 8 digital I/O and 4 analogue inputs. The module is powered from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm with positive core polarity, DC supplies are required to supply at least 500mA at 12vdc. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed and common pins are all available on the screw terminals.
Digital inputs are able to be configured to remotely control outputs on all of our new ethernet relay boards (both wired and WIFI), the older ETH-RLY02 and ETH-RLY16 are not compatible however. This offers the opportunity to construct a system where an input can control an output anywhere on the earth provided both locations are connected to the network/internet.
-40C to +70C
The WIFI484 provides an LED to indicate each of the relay states and three for board status, these are:
Board power - red LED
WIFI connected - yellow LED
USB connected - green LED
|Part. No. :||WIFI484|
Questions on WIFI484 - 4 Relays at 16A, 8 Digital IO and 4 Analogue Inputs
No questions asked yetFai una domanda (Registrati oppure Esegui il Login ).