Olimex

FEATURES Parallel port JTAG dongle interface, can be used with all ARM devices for programming and debugging uses ARM's standard 2x10 pin J...

AVR-ISP500-TINY is fast and reliable USB AVR programmer. It have two modes of work: STK500 compatible USB programmer and USB Mass storage. In ...

ARDUINO Leonardo like board with ATMEGA32U4. Features: ATMEGA32U4 microcontroller, all in one USB communication no need for external FTDI chip...

This is a rechargeable Li-Po high discharge current battery with JST connector ready to plug to: OLIMEXINO-328, OLIMEXINO-STM32, PIC32-PINGUINO, PI...

This is a rechargeable Li-Po high discharge current battery with JST connector ready to plug to: OLIMEXINO-328, OLIMEXINO-STM32, PIC32-PINGUINO, P...

A4983 driver can control stepper motors and have two channels. The board can also power gear motors. It might be supplied by voltage in the 6V to 3...

ADS1220 features two differential or four single-ended inputs through a flexible input multiplexer (MUX), a low-noise, programmable gain amplifier ...

Implements CH340 Fully open hardware design USB mini connector - USB 2.0 Full Speed compatible Serial interface with variable baud rate - 50 bps ...

BB-L298 is dual full bridge driver with up to 2.5A and 7-40V working voltage. It is good to drive Gear Robot motors with reversal function. STATUS ...

BB-VNH3SP30 is full bridge driver with up to 30A and 36V working voltage. It is good to drive Gear Robot motors with reversal function. STATUS LEDs...

Suitable for A10-OLinuXino-LIME GPIO connectors.

A 10-pin ribbon cable suitable for connecting an OLIMEX host board with UEXT interface to an extension board configured as device. Note that some o...

40-PIN RIBBON CABLE SUITABLE FOR A13-OLINUXINO

Input voltage range: (9-36)VDC Fixed output voltage: 5V or 12V selectable Screw terminal and power jack for input Screw terminal, USB-A connecto...

Allow your Raspberry Pi, A13-OLinuXino-MICRO, BeagleBone etc boards which require 5V input power supply to be powered with any adapter from 6 to 16...

DS18B20 is digital factory calibrated temperature sensor with 1-wire interface Cable length 100 cm Water proof encapsulated in stainless steel 6x...

DOOR-LOCK IS ELECTROMAGNETIC DOOR LOCK. IT OPERATES WITH 12V DC, WHEN POWER IS APPLIED THE DOOR LOCK PIN IS MOVING INSIDE HOUSING, WHEN POWER IS RE...

PROFESSIONAL STICKY ECG GEL ELECTRODES

ESP-EYE is development board for Espressif AI framework. It combines ESP32 with 2Mpix camera and ESP-WHO face detection and recognition development...

This is the ultimate IoT board with wired 100Mb Ethernet Interface, Bluetooth LE, WiFi, Remote control IR, and CAN connectivity. The board can oper...

This is the ultimate IoT board with wired 100Mb Ethernet Interface, Bluetooth LE, and WiFi. FEATURES ESP32-WROOM32 module Built-in programmer for...